HolyBro SiK Telemetry Radio V3 for APM2.6 Pixhawk PX4

This radio is plug-n-play all Pixhawk Standard and other Flight Controller, providing the easiest ways to set up a telemetry connection between your Autopilot and a ground station. It uses open-source firmware which has been specially designed to work well with MAVLink packets and to be integrated with the Mission Planner, Ardupilot, QGroundControl, PX4 Autopilot.

Note:
This radio does not support firmware upload via Mission Planner 1.3.75 or order.

Please use Mission Planner 1.3.75.1 or newer if firmware upload is needed.

Features

– Open-source SIK firmware
– Plug-n-play for Pixhawk Standard Flight Controllers
– Easiest way to connect your Autopilot and Ground Station
– Interchangeable air and ground radio
– Micro-USB port (Type-C Adapter Cable Included)
– 6-position JST-GH connector

– 100 mW maximum output power (adjustable) -117 dBm receive sensitivity
– RP-SMA connector
– 2-way full-duplex communication through adaptive TDM UART interface
– Transparent serial link
– MAVLink protocol framing
– Frequency Hopping Spread Spectrum (FHSS) Configurable duty cycle
– Error correction corrects up to 25% of bit errors Open-source SIK firmware
– Configurable through Mission Planner & APM Planner
– FT230X is a USB to BASIC UART IC

Dimensions
28 x 53 x 10.7mm (without antenna)

Electrical Data
– Supply voltage: 5V DC (from USB or JST-GH)
– Transmit current: 100 mA at 20dBm
– Receive current: 25 mA
– Serial interface: 3.3 V UART