iFlight SUCCEX-D F7 HD flight controller STACK (F7+60A ESC)

The SucceX-D F7 is designed to work seamlessly with DJI’s new HD FPV system. To make things as simple as possible, we have included a connector specifically for the DJI air unit, so installation should be a breeze. In addition, we add the popular and reliable USB Type-C instead of Micro USB which makes the connection easily.

• Universal USB Type C connector instead of micro USB
• Plug-and-Play. No need to solder tiny wires.)
• Supports BLHeli pass-through for easy ESC upgrade and configuration.
• Designed to support DJI Digital FPV.

SucceX-D F7 TwinG  SPECS：
– MCU：216MHz STM32F722RET6
– Gyro: 2x ICM20689
– Baro：YES
– Betaflight OSD：YES
– Blackbox: 32MB
– 5 x Uarts
– 8 x Motor outputs
– 8 pin 4in1 ESC port
– 4-pin VTX connector
– Betaflight Firmware：betaflight_4.0.5_STM32F7X2.hex
– CLI config：IFLIGHTF7_TWIN_G.config

Physical
– Mounting hole：30.5*30.5mm，φ4mm with Grommets φ3mm
– Size：36*36mm
– Weight：7.5g

SucceX 60A BLHeli_32 4-in-1 ESC
Features:
– 8 layers single-board stacking PCB board;
– 4oz 1.6mm thick power board(0.9mm copper ratio),better operating load capacity;
– 32bit FO51K86 MCU,48mHz running speed;
– TDK MLCC Low ESR ceramic capacitors;
– Top grade metal MOSFET;
– Rational layout, countersunk holes on extended motor soldering pad enable each layer board can be powered.

Specification:
– Dimension:43x39mm
– Mounting Holes: 30.5*30.5mm/Φ4mm
– Weight: 13.4g
– Supports 2-6S lipo input
– STM32F051 MCU, 48Mhz Runs BLHELI 32.X Firmware
– Current sensor: Yes
– BEC: No
– Supports: DShot DShot150/300/600/1200/MultiShot/ OneShot etc.
– Target: iFlight-BL32-4 in 1